595,00 € precio sin IVA (719,95 € IVA incluido)
Victron Phoenix MultiPlus Compact 12/800/35 charger pure sine wave inverter 800 w for 12 volt DC, 35 of charging current installations.
Multi functional, with
the MultiPlus intelligent power management brings together, in a single compact housing, a powerful sine inverter, a sophisticated battery charger with adaptable technology and a high-speed AC transfer switch. In addition to these main functions, the MultiPlus has several advanced features, as described below.
Two outputs CA
the main exit has the function "ups" (without interruption). The MultiPlus is responsible for supply to the loads connected in case of power failure or disconnection of the network power/generator. This happens so quickly (less than 20 milliseconds) that computers and other electronic equipment continue to operate without interruption. The second output is only active when she gets to one of the entrances of the MultiPlus AC power. Appliances that should not discharge the battery, such as a water heater, for example (second exit available only on models with 50A transfer switch) can be connected to this output.
Virtually unlimited power thanks to parallel
up to 6 Multis operation can operate in parallel to achieve higher power output. Six units 24/5000/120, for example, will give a power output of 25 kW/30 kVA and 720 amps charging capacity.
Capacity of three-phase operation
as well as the parallel connection, three units of the same model for three-phase output can be configured. But that's not all: up to 6 sets of three units that will provide a power output of 75 kW can be connected in parallel / 90 kVA and over 2000 amps of load capacity.
PowerControl - Limited power generator, shore or network
the Multi is a very powerful battery charger. Therefore, you will use much power generator or the network of shore (almost 10 A for each Multi from 5kVA to 230 VAC). In the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will take into account the other AC loads and will use the current surplus to load, avoiding thus overloading the generator or shore NET.
PowerAssist – Boosting the capacity of shore or generator power
this function takes the principle of PowerControl to a further dimension. It allows the MultiPlus to supplement the capacity of the alternative source. When a peak power is required for a short space of time, as it happens often, MultiPlus will immediately compensate the possible lack of power of the current of shore or generator power with battery power. When the load is reduced, the excess power is used to recharge the battery.
Variable charger of four stages and benches of double battery
master output load provides a powerful charge to the battery system by advanced software of "variable load". The software adjusts the automatic three stage process to adapt to the conditions of the battery accurately and adds a fourth stage for prolonged periods of slow loading. Variable load process is described in more detail in the Phoenix Charger data sheet and on our website, in the section "Technical information". In addition, the MultiPlus can charge a second battery using a limited independent charging output, intended for charging a starter battery of the main engine or generator (this output available in 12V and 24V models only).
The system configuration cannot be simple
once installed, the MultiPlus is ready to go. If you have to change the configuration, can be in a matter of minutes using a new procedure of the DIP switch settings. Switches DIP you can even program the parallel operation and the three phase: no computer needed! You can also use a VE.Net instead of the DIP switches.
And there is available a sophisticated software (VE.Bus Quick Configure and see.Bus System Configurator) to set up several new and advanced features.